Edge AWD V6-3.5L (2009)
restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt
assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to
follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Position the front seat forward.
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General
Procedures portion of Air Bag Systems.
3. Remove the front door scuff plate.
-
Pull up to release the 5 retaining clips.
4. Remove the rear door scuff plate.
-
Pull up to release the 2 retaining clips.
5. Detach the 2 clips and remove the lower B-pillar trim panel.
6. NOTE: Inspect the safety belt retractor and pretensioner D-ring cover for damage. If the D-ring cover does not remain in place, install a new
cover.
Remove the D-ring cover.
7. Remove the bolt and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
8. Remove the safety belt retractor and pretensioner anchor nut cover from the seat.
9. NOTE: Note the position of the safety belt retractor and pretensioner anchor and the anti-rotation pin on the seat for correct installation.
Remove the nut and safety belt retractor and pretensioner anchor.
-
To install, tighten to 47 Nm (35 lb-ft).
10. NOTE: Note the position of the safety belt retractor and pretensioner locator T-tab in the B-pillar sheet metal for installation.
Disconnect the electrical connector, remove the bolt and safety belt retractor and pretensioner.
-
To install, tighten to 40 Nm (30 lb-ft).
11. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
12. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General
Procedures portion of Air Bag Systems.
13. Check the active restraint system for correct operation.
