Edge AWD V6-3.5L (2009)
3. NOTE: Inspect the rear safety belt retractor D-ring cover for damage. If the D-ring cover does not remain in place, install a new cover.
Remove the rear safety belt retractor D-ring cover.
4. Remove the bolt and rear safety belt retractor D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the bolt and rear safety belt retractor.
-
Lift up to release the locator T-tab from the C-pillar sheet metal.
-
To install, tighten to 40 Nm (30 lb-ft).
6. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System. See: Testing and Inspection/Component Tests and General Diagnostics
