Edge AWD V6-3.5L (2009)
Power Trunk / Liftgate Lock Switch: Service and Repair
Liftgate Release Switch - Manual
Liftgate Release Switch - Manual
Removal and Installation
1. Remove the liftgate trim panel.
2. Disconnect the liftgate release switch molding electrical connector.
3. Remove the 5 liftgate release switch moulding nuts.
-
To install, tighten to 12 Nm (106 lb-in).
4. Press the tabs and remove the liftgate release switch.
5. Disconnect the liftgate release switch electrical connector.
6. To install, reverse the removal procedure.