Edge AWD V6-3.5L (2009)
Power Steering Fluid Cooler: Service and Repair
Power Steering Fluid Cooler
Removal and Installation
NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power
steering components may result.
1. Using a suitable suction device, remove the power steering fluid from the reservoir.
2. Remove the front bumper cover.
3. Release the clamps and disconnect the 2 return hoses from the power steering fluid cooler.
4. Remove the power steering fluid cooler-to-subframe bolt.
-
To install, tighten to 9 Nm (80 lb-in).
5. Remove the 2 power steering fluid cooler nuts.
-
To install, tighten to 7 Nm (62 lb-in).
6. To install, reverse the removal procedure.
7. Fill the power steering system.
