Edge AWD V6-3.5L (2009)
10. NOTE: During the passenger air bag module installation, make sure all 7 of the air bag trim cover hooks are fully seated in the instrument panel.
Install the passenger 7 air bag trim cover hooks into the instrument panel. Raise the rear of the passenger air bag module onto the 3 mounting
studs.
11. Install the 3 passenger air bag module nuts.
-
Tighten to 7 Nm (62 lb-in).
12. NOTE: To avoid a squeak or rattle condition, install the passenger air bag module bracket and passenger air bag module bolts in this order.
Install the passenger air bag module support bracket and the 4 bolts.
1. Install the passenger air bag module support bracket and 2 bolts to the cross vehicle beam.
-
Tighten to 8 Nm (71 lb-in).
2. Install the inboard passenger air bag module support bracket-to-passenger air bag module bolt.
-
Tighten to 8 Nm (71 lb-in).
3. Install the outboard passenger air bag module support bracket-to-passenger air bag module bolt.
-
Tighten to 8 Nm (71 lb-in).
13. Install the screw and the RH duct assembly.