Edge AWD V6-3.5L (2009)
10. Position a suitable jackstand under the lower arm.
11. Remove and discard the lower shock bolt and nut.
12. Remove and discard the upper arm outboard bolt and nut.
13. Remove and discard the lower arm outboard bolt and nut.
14. Remove and discard the toe link outboard bolt and nut.
AWD vehicles
15. Position the halfshaft through the wheel knuckle opening and secure the halfshaft aside.
All vehicles
16. Remove the 5 wheel knuckle bracket-to-frame bolts and the wheel knuckle.
-
Discard the bolts.
17. Remove and discard the wheel knuckle bracket bolt nut.
Installation
All vehicles
NOTICE: Suspension bushing fasteners must be tightened with the weight of the vehicle resting on the wheel and tires or incorrect clamp load
and bushing damage may occur.
1. Install the new wheel knuckle bracket bolt and nut.
-
Tighten the bolt to 150 Nm (111 lb-ft).
2. Position the wheel knuckle and install the 5 new wheel knuckle bracket-to-frame bolts.
-
Tighten the bolts to 47 Nm (35 lb-ft).
AWD vehicles
3. Position the halfshaft into the wheel bearing and wheel hub.
