Edge AWD V6-3.5L (2009)
-
Support the brake caliper and anchor plate assembly using mechanic's wire.
3. Remove the brake disc.
4. Remove the nut and disconnect the stabilizer bar link and parking brake cable bracket from the wheel knuckle.
-
Discard the nut.
5. Remove the bolt and position the wheel speed sensor aside.
-
If equipped, unclip the 2 retainers from the upper arm.
6. Remove the brake hose bracket bolt and position the hose aside.
All-Wheel Drive (AWD) vehicles
NOTE: Do not discard the wheel hub nuts at this time.
7. Remove the outer and inner wheel hub nuts.
8. Using the Front Hub Remover, separate the halfshaft from the hub and bearing.
All vehicles
9. Position a suitable jackstand under the lower arm.
10. Remove and discard the shock absorber lower nut and flag bolt.
11. Remove and discard the upper arm outboard bolt and nut.
12. Remove and discard the toe link outboard bolt and nut.
13. Remove and discard the lower arm outboard bolt and nut.
AWD vehicles
14. Position the halfshaft through the wheel knuckle opening and secure the halfshaft aside.
All vehicles
15. WARNING: The coil spring is under extreme load. Care must be taken at all times when removing or installing a loaded spring. Failure
