Edge AWD V6-3.5L (2009)
to follow this instruction may result in serious personal injury.
Pull outward on the wheel knuckle while lowering the jackstand and remove the spring.
-
Inspect the spring upper and lower seats, remove and discard seats as necessary.
Installation
All vehicles
1. If removed, position a new lower seat into the lower arm with the recess in the seat aligned with the projection on the lower arm.
2. Position the spring onto the lower arm with the end of the spring 0-10 mm (0-0.39 in) from the step on the spring seat.
3. WARNING: The coil spring is under extreme load. Care must be taken at all times when removing or installing a loaded spring. Failure
to follow this instruction may result in serious personal injury.
Pull outward on the wheel knuckle and install the spring.
All-Wheel Drive (AWD) vehicles
4. Position the halfshaft into the wheel bearing and wheel hub.
All vehicles
5. Raise the jackstand and loosely install the new lower arm outboard bolt and nut.
6. Position the toe link and loosely install the new toe link outboard bolt and nut.
7. Position the upper arm and loosely install the new upper arm outboard bolt and nut.
8. Loosely install the new lower shock nut and flag bolt.
