Edge AWD V6-3.5L (2009)
-
Tighten the roll restrictor-to-transaxle through bolt to 115 Nm (85 lb-ft).
16. Install the roll restrictor-to-subframe through bolt.
-
Tighten to 103 Nm (76 lb-ft).
17. Install the roll restrictor heat shield and the 2 nuts.
-
Tighten to 11 Nm (97 lb-in).
18. Position the exhaust Y-pipe assembly in place and install a new gasket and 4 new nuts.
-
Tighten to 40 Nm (30 lb-ft).
19. Install the 2 exhaust hangers and tighten the exhaust clamp.
-
Tighten to 40 Nm (30 lb-ft).
20. Check the transmission fluid level and fill with clean transmission fluid to the correct level.
