Edge AWD V6-3.5L (2009)
25. Remove the bolt and the TSS sensor.
Installation
1. Route the TSS sensor wiring harness through the cover and the transaxle case.
-
Tighten to 12 Nm (106 lb-in).
2. Install the TSS sensor in the cover and install the bolt.
-
Tighten to 12 Nm (106 lb-in).
3. NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
