Edge AWD V6-3.5L (2009)
10. Connect the TR sensor electrical connector.
1. Connect the electrical connector.
2. Slide the locking tab over.
11. Connect the TSS sensor electrical connector.
12. Inspect the transaxle side cover seal for damage and install new if necessary.
13. NOTICE: Inspect the 20-pin solenoid body connector seal to make sure that the seal is on the inside of the main control cover or a
transmission fluid leak will occur.
NOTE: Install the studbolts in the locations noted during disassembly.
Install the main control cover and install the 14 bolts.
1. Bolt location
2. Studbolt location
