Edge AWD V6-3.5L (2009)
14. Tighten the main control cover bolts in the sequence shown.
-
Tighten to 12 Nm (106 lb-in).
15. Position the transmission fluid cooler thermal bypass valve and transmission fluid cooler tube assembly in place and install the 2 transmission fluid
cooler line bracket nuts.
-
Tighten to 9 Nm (80 lb-in).
16. Connect the transaxle electrical connector.
17. NOTICE: Make sure that when installing the manual control lever it is fully seated onto the manual control lever shaft or damage to the
manual control lever shaft will occur and the lever will come loose.
NOTICE: Make sure to hold the manual control lever while tightening the manual control lever nut or damage to the manual control
lever and park components will occur.
