Edge AWD V6-3.5L (2009)
body can occur.
NOTICE: Use care not to break the alignment tabs when installing the solenoid body filter. Damage to the transaxle will occur if the
solenoid body is not correctly aligned.
Remove the solenoid body filter assembly by pulling it straight up from the alignment tabs. Discard the filter.
24. Remove the 10 bolts, the TR sensor detent spring and the main control valve body.
Installation
1. NOTE: If cleaning of the main control assembly or inspecting the valves, refer to Identification Tags. If installing a new main control assembly
continue with this procedure. See: Application and ID
NOTE: Make sure that the manual control lever pin (part of the TR sensor) is correctly installed in the manual control valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body, the TR sensor detent spring and the 10 bolts.
Tighten the bolts in the sequence shown.
-
Tighten to 12 Nm (106 lb-in).
2. NOTICE: Do not handle the solenoid body in the leadframe area or by the screens of the solenoid body filter or damage to the solenoid
body can occur.