Edge AWD V6-3.5L (2009)
1. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle See: Steering and Suspension/Steering/Front Steering
Knuckle/Service and Repair.
2. Using the Step Plate and a suitable press, remove the wheel hub from the wheel bearing.
3. NOTE: This step may not be necessary if the inner wheel bearing race remains in the wheel knuckle after removing the wheel hub.
Using the Pinion Bearing Cone Remover and a suitable press, remove the inner wheel bearing race from the wheel hub.
4. Remove the snap ring.
5. Using the Wheel Hub Cup Remover/Installer and a suitable press, remove the outer wheel bearing race from the wheel knuckle.
Installation
1. Using the Wheel Hub Bearing Cup Installer and a suitable press, install the wheel bearing into the wheel knuckle.
2. Install the snap ring.
3. Using the Wheel Hub Bearing Cup Installer, Step Plate and a suitable press, install the wheel hub into the wheel bearing.
4. Install the wheel knuckle. For additional information, refer to Wheel Knuckle See: Steering and Suspension/Steering/Front Steering
