Edge AWD V6-3.5L (2009)
5. Using the Front Hub Remover, separate the halfshaft from the hub and bearing assembly.
6. Remove the brake hose bracket bolt.
7. Remove the wheel speed sensor bolt and detach the sensor from the wheel knuckle.
8. Unclip the wheel speed sensor harness from the upper arm and position the wheel speed sensor assembly aside.
9. Remove and discard the upper arm outboard bolt and nut.
-
Separate the upper arm from the wheel knuckle.
10. Position a suitable screw type jack stand under the lower arm.
11. Remove and discard the shock absorber lower bolt and nut.
12. Remove and discard the stabilizer bar link upper nut.
13. Remove and discard the toe link outboard bolt and nut.
14. With the wheel knuckle supported by the screw type jack stand, remove and discard the toe link outboard bolt and nut.
15. Position the halfshaft up through the wheel knuckle opening.
Front Wheel Drive (FWD) vehicles
16. Remove the wheel speed sensor bolt and detach the sensor from the wheel bearing and wheel hub.
All vehicles
17. Remove the 4 bolts and the wheel bearing and wheel hub.
-
Discard the bolts.
Installation
All vehicles
NOTE: Before tightening the upper arm and lower arm bolts, use a jackstand to raise the rear suspension until the distance between the center of the hub
and the lip of the fender is equal to the measurement taken in the removal procedure (curb height).
