Edge AWD V6-3.5L (2009)
Windshield Washer Pump: Service and Repair
Washer Pump
Removal and Installation
1. Remove the RH front fender splash shield.
2. NOTICE: When replacing the washer pump, be careful not to damage the rubber grommet.
NOTE: To prevent spilling windshield washer fluid, drain the washer reservoir before washer pump removal.
Remove the washer pump.
1. Disconnect the electrical connector.
2. Disconnect the hoses.
3. Remove the washer pump.
3. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow these instructions may result in
premature pump failure.
To install, reverse the removal procedure.
-
Fill the washer reservoir with windshield washer fluid.
