Edge FWD V6-3.5L (2007)
Part 2
Removal and Installation
Upper and lower cowl grille panel
1. NOTE: The upper cowl panel grille must be removed before the lower cowl panel grille can be removed.
Remove the LH and RH wiper pivot arms.
Upper cowl panel grille
2. Remove the RH cowl side outer panel.
3. Remove the LH cowl side outer panel.
4. Remove the 2 scrivets from the RH upper cowl panel grille.
5. Remove the 2 bolts from the RH upper cowl grille panel and remove the RH upper cowl grille panel.
-
To install, tighten to 6 Nm (53 lb-in).
6. Remove the 2 scrivets from the LH upper cowl grille panel.
7. Remove the 2 bolts from the LH upper cowl grille panel and remove the LH upper cowl grille panel.
-
To install, tighten to 6 Nm (53 lb-in).
Lower cowl panel grille
8. Remove the wiper arm and wiper pivot shaft assembly.
-
Disconnect the electrical connector.
-
Remove the 2 bolts.
-
To install, tighten to 7 Nm (62 lb-in).
9. Remove the 2 bolts from the upper left lower cowl grille panel extension and remove the panel.
-
To install, tighten to 6 Nm (53 lb-in).
10. Remove the 4 bolts from the upper right lower cowl panel extension and remove the panel.
-
To install, tighten to 6 Nm (53 lb-in).
11. Disconnect the wiring harness from the retainer on the left front of the lower cowl grille panel.