Edge FWD V6-3.5L (2007)
15. Remove the 2 front (1 each side) mounting nuts from the rear subframe.
-
Discard the nuts.
-
To install, tighten to 90 Nm (66 lb-ft).
16. NOTE: The bolts are 2 different sizes, note the location of the bolts to make sure of correct installation.
Remove the 10 bolts (5 each side) from the trailing links-to-vehicle body.
-
Discard the bolts.
-
To install, tighten to 47 Nm (35 lb-ft).
17. NOTE: The rear springs are under pressure. The lifting table must be lowered slowly to relieve the spring pressure.
Remove the 2 rear mounting nuts.
-
Discard the nuts.
-
To install, tighten to 90 Nm (66 lb-ft).
