Edge FWD V6-3.5L (2007)
Remove the air deflector-to-track screw and air deflector arm capture plate on the affected track.
4. NOTE: LH shown, RH similar.
Remove the air deflector catcher bracket outer screw on the affected track.
5. Remove the front shade assembly.
6. Remove the roof opening panel sliding glass motor.
7. Move the sliding glass mechanism to the full forward position on the affected track.
8. Remove the front drive tube bracket-to-guide-track screw.
9. NOTE: Carefully mark the location of the guide track in 3 places before removing any fasteners. The new guide track must be installed in exactly
the same position.
Remove the 8 front track-to-housing screws.
10. CAUTION: Protect the vehicle interior from grease when cable assembly is withdrawn from the drive tube.
Drop the front of the guide track down while sliding the entire track and mechanism assembly forward and down. The drive cable will slowly
withdraw from the drive tube until the entire assembly is free.
Installation
1. CAUTION: Protect the vehicle interior from grease when cable assembly is inserted into the drive tube.
While holding the track and mechanism assembly, slowly insert the sliding glass drive cable into the drive tube. Insert the shade cable into the
