Edge FWD V6-3.5L (2007)
Power Seat Motor: Service and Repair
Power-Fold Seat Motor - Rear Seat
POWER-FOLD SEAT MOTOR - REAR SEAT
Removal and Installation
1. Remove the affected 40 percent or 60 percent seat.
2. Remove 2 screws and the outboard lower side shield.
3. Remove the power fold motor in the following sequence.
1. Remove the 2 screws from the power fold motor.
2. Slide the cable housing out of the recliner.
3. Turn the cable end so the tab aligns with the slot in the lever and separate the cable.
4. Remove the power fold motor.
4. To install, reverse the removal procedure.