Edge FWD V6-3.5L (2007)
6. Disconnect the fuel vapor tube assembly quick connect coupling from the fuel tank.
7. Position a suitable lifting device under the fuel tank.
8. Remove the 2 fuel tank bracket bolts and the 4 fuel tank mounting bolts. Partially lower the fuel tank enough to access the 2 rear fuel vapor tube
assembly retainer clips.
-
To install, tighten to 25 Nm (18 lb-ft).
9. Remove the fuel vapor tube assembly from the 2 rear retainer clips.
10. Remove the fuel vapor tube assembly.
11. To install, reverse the removal procedure.
-
Carry out a leak test. See: Testing and Inspection
-
Carry out the evaporative emission repair verification drive cycle.