Edge FWD V6-3.7L (2011)
Attachment II - Labor and Parts Information
10B20110107-005
LABOR ALLOWANCES
PARTS REQUIREMENTS / ORDERING INFORMATION
Parts are not required to complete this repair.
Attachment III - Technical Information
OVERVIEW
Dealers are to reprogram the SYNC system to the latest level. This software update will provide enhanced overall system functionality and incorporate
some improved media features and driver services.
REQUIRED TOOLS
1. SYNC Re-Flash Kit # CCMSYNC-KIT or equivalent (required for performing a Full Flash) - USB cable and USB adapter called out in the WSM,
Section 415-00/or equivalent Type A Male to mini type B 5 pin female USB cable.
NOTE:
One equivalent Molex(R) cable adapter # 689990425-101123D was shipped to each dealer in support of TSB 10-24-09 in December of 2010.
2. USB flash drive
^
Minimum storage size of 1 gigabyte (GB).
^
The USB flashdrive should be a basic drive that does not contain any file organizing software or smart functions.
3. Battery power supply/charger
^
The battery icon displayed in the lower right hand corner of the scan tool will be green when battery voltage is adequate.
^
The negative battery charger lead must be connected to chassis ground to allow the vehicle's Load Shed strategy to accurately monitor the battery
state of charge during programming. Do not connect the negative lead to the negative battery terminal.
4. IDS and internet
^
IDS software release 70.03A and higher or 71.01 and higher is required.
^
Hard wired internet connection is strongly recommended.
^
Minimum of 3 GB of free disk space on the scan tool.
5. Firsttime IDS Preparation
^
A Hardware Wizard pop up requesting a WMA SBOOT driver installation may occur while programming. If the request is encountered, install
the driver and then click the scan tool retry button to continue programming. This driver installation will occur only once on the scan tool's first
"MyFord Touch Full Flash reprogramming" attempt.
^
If reprogramming concerns occur, refer to Software Programming Vi.1 on the Professional Technician Society (PTS) web site under the Service
Tip tab to verify proper configuration of the IDS. If reprogramming concerns can not be resolved, contact the Tech Service Hotline using the
standard HAR process.
6. Additional Information
A My Touch programming video and FAQs are available on the PTS web site. To locate this information from the OASIS tab, select the "Service
Tips" tab. The video and FAQs are listed under "Job Aids".
SYNC APPLICATION SELECTION
