Edge FWD V6-3.7L (2011)
6. Remove the 3 power steering tube bracket bolts from the RH side of the subframe and position the power steering tube aside.
-
To install, tighten to 9 Nm (80 lb-in).
7. NOTE:
-
Use the holding feature to prevent the ball stud from turning while removing or installing the stabilizer bar link nut.
-
RH side shown, LH side similar.
Remove the 2 stabilizer bar link-to-control arm nuts (1 each side) and separate the stabilizer bar links from the lower control arms.
-
Discard the nuts.
-
To install, tighten to 90 Nm (66 lb-ft).
8. NOTE: RH side shown, LH side similar.
Remove the lower control arm-to-knuckle pinch bolts and separate the lower control arms from the knuckles.
-
Discard the bolts.
-
To install, tighten to 55 Nm (41 lb-ft).
