Edge FWD V6-3.7L (2011)
-
Discard the bolts.
-
To install, tighten to 200 Nm (148 lb-ft).
16. NOTE: The bolts are 2 different sizes, note the location of the bolts to make sure of correct installation.
Remove the 10 bolts (5 each side) from the trailing links-to-vehicle body.
-
Discard the bolts.
-
To install, tighten to 47 Nm (35 lb-ft).
17. NOTE: The rear springs are under pressure. The lifting table must be lowered slowly to relieve the spring pressure.
Remove the 2 rear mounting bolts.
-
Discard the bolts.
-
To install, tighten to 200 Nm (148 lb-ft).
18. Remove the rear subframe.
19. Transfer the components as necessary.
20. To install, reverse the removal procedure.