Edge FWD V6-3.7L (2011)
NOTE: There are 2 Rear Drive Unit (RDU) bushings in the rear subframe, this procedure shows how to remove one bushing. The procedure for the
remaining RDU bushing is identical.
1. Remove the RDU.
2. NOTE:
-
Make sure the Rear Drive Unit (RDU) Bushing Remover/Installer 204-617/2 is positioned with the larger opening toward the bushing to act as
the receiver cup.
-
Make sure the arrow on the special tool is pointed toward the rear subframe when removing the bushing.
Assemble the Rear Drive Unit (RDU) Bushing Remover/Installers to the rear subframe and press out the bushing.
Installation
NOTE: There are 2 RDU bushings in the subframe, this procedure shows how to install one bushing. The procedure for the remaining RDU bushing
is identical.
1. NOTE: Make sure the alignment marks on the special tool are aligned with the anti-rotation tabs on the RDU bushing.
Install the RDU bushing into the Rear Drive Unit (RDU) Bushing (65 mm) Remover/Installer.
2. NOTE: Make sure the alignment marks are correctly aligned on both RDU Bushing Remover/Installer and the anti-rotation tabs are correctly
seated in the Rear Drive Unit (RDU) Bushing (65 mm) Remover/Installer.
Install the Rear Drive Unit (RDU) Bushing (65 mm) Remover/Installer onto the RDU bushing.
3. Inspect the rear subframe to find the revision part number.
