Edge FWD V6-3.7L (2011)
9. Loosen the Y-pipe clamp and disconnect the 2 exhaust hangers.
-
To install, tighten to 40 Nm (30 lb-ft).
10. Remove the 4 nuts and the Y-pipe assembly.
-
To install, tighten to 40 Nm (30 lb-ft).
11. NOTE:
-
The steering gear is not removed with the front subframe and must be positioned aside.
-
Position the steering gear aside using mechanic's wire.
Remove the 4 bolts and position the steering rack aside using a suitable length of mechanic's wire.
-
Discard the bolts.
-
To install, tighten the steering gear bolts in the sequence shown.
-
To install, tighten to 103 Nm (76 lb-ft).
12. Remove the 4 bolts and position the stabilizer bar aside using a suitable length of mechanic's wire.
