Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
Trunk / Liftgate Latch: Service and Repair
Liftgate Latch
REMOVAL
1. Remove the liftgate trim panel.
2. Disconnect the liftgate ajar switch electrical connector.
3. Disconnect the liftgate latch actuating rod.
1
Open the clip.
2
Disconnect the actuating rod.
4. Remove and discard the liftgate latch bolts.
5. Remove the liftgate latch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
^
Make sure the liftgate latch release rod is not pre loading the latch. It should be clipped in a relaxed state with no slack.
^
Position the liftgate latch release rod by pushing outboard to remove the slack.