Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
7. Install the supplied convolute tubing over the spliced area and secure with electrical tape. Apply tape to the entire length of the convolute and be sure
to secure the convolute to the elbow at one end, and as close as possible to the ABS connector on the other. See Figure 12.
8. Reinstall the dress cover and use electrical tape to secure the cover at the same location where the original tie strap was removed. Apply Motorcraft
Electrical Grease XG-12 to the ABS module connector, position and connect the harness as follows:
a) Reinstall the dress cover.
b) Use ONLY Motorcraft Electrical Grease XG-12. See Figure 13.
-
With the tip of the applicator tube snipped off, position the end of the tip between the 4 large flat pins at the bottom of the ABS module
