Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
Brake Fluid Reservoir
Removal
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal inquiry.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Disconnect the fluid level electrical connector.
2. Using a suitable suction device, drain the brake master cylinder reservoir.
3. If equipped with manual transmission, disconnect the clutch master cylinder feed.
4. Remove the brake master cylinder reservoir.
Installation
NOTE: Whenever installing a new brake master cylinder reservoir, install new seals.
