Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
Brake Bleeding: Service and Repair
Brake Master Cylinder - In-Vehicle Bleed
Brake Master Cylinder-In-Vehicle Bleed
WARNING: Use of any other than the approved DOT 3 brake will cause permanent damage to brake components and will render the
brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and Polyglycol. Avoid contact with eyes. Wash hands thoroughly after handling. If brake
fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
NOTE: When any part of the hydraulic system has been disconnected for repair or a new component is installed, air may enter the system, causing
spongy brake pedal action. This requires the bleeding of the hydraulic system after it has been correctly connected.
1. Disconnect the brake outlet lines from the brake master cylinder and cap the lines.
2. Install short brake hoses to the master cylinder outlet ports with the ends submerged in the brake master cylinder reservoir.
3. Fill the brake master cylinder reservoir with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification
ESA-M6C25-A, DOT 3.
4. Have an assistant pump the brake pedal until clear, bubble-free brake fluid flows from both brake hoses.
5. Remove the short brake hoses and install the brake outlet lines.
