Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
Brake Bleeding: Service and Repair
Brake Master Cylinder - Bench Bleed
Brake Master Cylinder-Bench Bleed
WARNING: Use of any other than the approved DOT 3 brake will cause permanent damage to brake components and will render the
brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
NOTE: When any part of the hydraulic system has been disconnected for repair or a new component is installed, air may enter the system, causing
spongy brake pedal action. This requires the bleeding of the hydraulic system after it has been correctly connected.
1. Support the brake master cylinder body in a soft jaw vise, and fill the brake master cylinder reservoir with specified brake fluid.
^
Use High Performance DOT 3 Brake Fluid C6AZ-19542-AB or equivalent meeting Ford specification ESA-M6C25-A, DOT 3.
2. Install plugs in the front and rear brake outlet ports.
3. Loosen the plug in the front outlet port and slowly depress the primary piston.
