Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
b) Use ONLY Motorcraft Electrical Grease XG-12. See Figure 15.
-
With the tip of the applicator tube snipped off, position the end of the tip between the 4 large flat pins at the bottom of the ABS module
connector. Squeeze out enough grease to completely cover the 4 flat pins. See Figure 15. DO NOT spread the grease around the connector.
Applying an excess amount of grease into the connector cavity will cause a hydro lock" condition in which the connector will not be able to
be seated fully or locked in place.
3. Reposition the harness to its original position, install the retainers to the studs to secure the harness and connect it to the ABS module.
4. Reconnect the battery negative terminal.
LABOR OPERATION E - INSTALL PIGTAIL, NEW ABS MODULE AND APPLY ELECTRICAL GREASE
IMPORTANT SERVICE INFORMATION
When performing the service pigtail installation, it is critical that the crimp tool and the flameless heat gun found in the Rotunda Wire Splice Tool Kit /
64-R5903 be used.
