Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
a.
If the tab is missing, damaged, or detached from the rim on ANY of the sockets, replace the windshield wiper mounting arm and pivot shaft
assembly. Refer to the service procedures in section 501-16 of the appropriate Workshop Manual. See Figure 5.
b.
If the tab is aligned but not fully engaged into the corresponding hole in the link on ANY one of the sockets but is not otherwise damaged or
detached from the rim, press the tab with your thumb (no tools) to fully engage it in the hole. If force greater than thumb pressure is required
to engage the tab into the hole, replace the windshield wiper mounting arm and pivot shaft assembly. Refer to the service procedures in
section 501-16 of the appropriate Workshop Manual. See Figure 6.
