Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
of the appropriate Workshop Manual. See Figure 8.
e.
Inspect the dome section of the sockets for cracks. If grease is present on the dome of the socket, this may be evidence of a crack. If ANY
one of the sockets is cracked, replace the windshield wiper mounting arm and pivot shaft assembly. Refer to the service procedures in
section 501-16 of the appropriate Workshop Manual. See Figure 9.
If the wiper module passes all the inspections described in A-E, no replacement is required.
8.
Install the wiper module. Tighten the bolts to 12 Nm (107 lb-in).
WARNING:
THE IGNITION KEY MUST BE IN THE "OFF" POSITION BEFORE CONNECTING THE WIPER MOTOR. IF NOT, SUDDEN
MOVEMENT OF THE WIPER LINKS MAY OCCUR WHEN THE MOTOR IS CONNECTED.
9.
Connect the wiper motor electrical connector.
10.
Install the left side cowl vent panel.
CAUTION
The wiper motor must be in the "PARK" position before installing the wiper arms or damage to the vehicle will result.
11.
Cycle and park the wiper motor.
CAUTION
Proper torquing of the wiper arm nuts is critical.
12.
Install the windshield wiper arms. Tighten the nuts to 35 Nm (26 lb-ft).
