Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
13. Attach the restraint system diagnostic tool to the driver safety belt buckle pretensioner floor electrical connector.
14. Disconnect the driver side air bag module electrical connector.
1
Slide and release the driver side air bag module electrical connector locking clip.
2
Disconnect the driver side air bag module electrical connector.
15. Attach the restraint system diagnostic tool to the driver side air bag module floor electrical connector.
16. Connect the battery ground cable.
17. With the restraint system diagnostic tools installed at all deployable devices, prove out the air bag system. See: Air Bag Systems/Air Bag(s)
Arming and Disarming/Service and Repair/Prove Out Procedure
18. Disconnect the battery ground cable and wait at least one minute.
19. Position the carpet back at the right-hand side of the center tunnel area under the instrument panel.
20. Remove the right-hand side restraint control module (RCM) retaining bolts.
21. Position the carpet back at the left-hand side of the center tunnel area under the instrument panel.
