Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
3. Remove the safety belt and buckle assembly.
1
Position the carpet out of the way.
2
Using the special tool, remove the bolt.
3
Feed the safety belt and buckle through the carpet and remove the assembly.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
^
Make sure the safety belt webbing is not twisted after repositioning the seat.
^
Make sure that the safety belt and buckle are accessible after repositioning the seat.
^
Make sure to tighten the bolt to specification.
2. Check the restraint system for correct operation.
Rear Safety Belt and Retractor
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT
ASSEMBLIES (SLIDE BAR), SHOULDER BELT HEIGHT ADJUSTERS (IF SO EQUIPPED), CHILD SAFETY SEAT TETHER
ATTACHMENTS, AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY COLLISION. ALL BELT ASSEMBLIES
SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THE ASSEMBLIES SHOW NO DAMAGE AND OPERATE
PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER
DAMAGE OR IMPROPER OPERATION IS NOTED.
NOTE: The driver side is shown, the passenger side is similar.
