Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
2. Route the safety belt buckle and pretensioner wire harness as noted in removal. Install the wire harness and electrical connector pin-type retainers.
3. Align the retaining clips and push in, installing the inboard seat cushion side shield.
4. Install the affected seat into the vehicle.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
NOTE: Make sure to follow all steps and instructions in the installation procedure of the affected seat.
5. With all the restraint system diagnostic tools removed, prove out the air bag system. See: Air Bag(s) Arming and Disarming/Service and
Repair/Prove Out Procedure
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
6. Check the active restraint system for correct operation.
