Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
1. Install the side crash sensor.
1
Position the side crash sensor to the B-pillar.
2
Install the bolts.
3
Connect the side crash sensor electrical connector.
WARNING: THE TIGHTENING TORQUE OF THE AIR BAG SIDE CRASH SENSOR RETAINING BOLTS IS CRITICAL FOR
PROPER SYSTEM OPERATION.
2. Connect the battery ground cable.
3. With the restraint system diagnostic tools still in place at all deployable devices, prove out the air bag system. See: Air Bag Systems/Air Bag(s)
Arming and Disarming/Service and Repair/Prove Out Procedure
4. Disconnect the battery ground cable and wait at least one minute.
5. Install the B-pillar trim panel.
6. Remove the restraint system diagnostic tool from the driver safety belt buckle pretensioner floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
7. Connect the driver safety belt buckle pretensioner electrical connector. Install the driver safety belt buckle pretensioner electrical connector onto
the bracket under the seat.
