Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
1. CAUTION: Install a new power steering pump pulley after the second removal and installation.
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, install a new pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub. Using the special tool, install the power steering pump pulley.
2. Using the special tool, install a new seal on the power steering pressure hose fitting.
^
Remove and discard the original seal.
^
Stretch the seal over the seal replacer and slide it onto the tube nut.
3. Position the power steering pump and install the upper bolts.
4. Connect the power steering low pressure hose.
