Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
8.
Install the mass damper and finger tighten the bolts. Torque the damper as follows. See Figure 8.
^
Step 1: Torque rear damper bolt to 4 Nm (35 LB-INCHES) MAXIMUM.
^
Step 2: Torque front bottom damper bolt to 48 Nm (35 lb-ft).
^
Step 3: Torque front top damper bolt to 48 Nm (35 lb-ft).
^
Step 4: Torque rear bottom damper bolt to 48 Nm (35 lb-ft).
9.
Connect the electrical connector to the rotary blade coupling.
10.
Remove the fill plug from the differential cover.
11.
Fill differential with approximately 2 pints of XY-80W90-QL rear axle lubricant. Fluid level should be between 6 mm (1/4 inch) and 14 mm (9/16
inch) from bottom of filler plug opening.
12.
Tighten the fill plug to 27 Nm (20 lb-ft).
13.
Return to Step No.7 to complete driveshaft installation procedure.
