Escape 2WD L4-122 2.0L DOHC VIN B SFI (2001)
2. Trim the remaining urethane adhesive on the pinch weld to within the specification.
^
The existing urethane adhesive surface should be smooth and free of cuts and contamination.
CAUTION: Do not scratch the pinch weld area.
3. Use a wool applicator to apply Urethane Metal Primer Essex U-413 meeting Ford specification WSB-M2G234-C to any exposed metal on the
pinch weld. Allow 6 to 10 minutes to dry.
4. If reinstalling the original windshield glass, remove the excess urethane adhesive and the windshield moulding.
5. Clean the inside of the windshield glass surface with an alcohol-free cleaner making sure the ceramic coated area is clean.
6. If installing a new windshield glass, apply Urethane Glass Prep Essex U-401 meeting Ford specification WSB-M2G314-B twice around the glass
surface to be urethaned.
NOTE: Wipe off the glass prep immediately after each application because it flash dries.
7. If installing a new windshield, apply Glass Primer Essex U-402 meeting Ford specification WSB-M5B280-C to the same area that was prepped in
the pervious step. Allow five minutes to dry.
8. Apply foam dam meeting Ford specification EBS-M3G137-A to the bottom of the windshield glass.
9. Cut the urethane adhesive applicator tip to specification.
