Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
Brake Lamp: Initial Inspection and Diagnostic Overview
INSPECTION AND VERIFICATION
1. Verify the customer concern by operating the stoplamps.
Visual Inspection Chart
2. Visually inspect for obvious signs of mechanical and electrical damage.
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. If the fault is not visually evident, verify the symptom and proceed to the Symptom Chart. See: Symptom Related Diagnostic Procedures