Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
Accelerator Pedal: Service and Repair
Cable
REMOVAL
1. Disconnect the accelerator cable from the throttle lever and bracket.
1
Disconnect the accelerator cable from the throttle lever.
2
Disconnect the accelerator cable from the bracket.
2. Disconnect the accelerator cable from the pedal.
3. Remove the accelerator cable.
1
Remove the bracket bolt.
2
Discount the accelerator cable from the air cleaner outlet tube.
3
Remove the accelerator cable from the dash panel.
CAUTION: Do not pull the accelerator cable out by the cable housing.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: To ease installation, remove the grommet from the throttle lever and install it onto the accelerator cable end.
