Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
AN AIR BAG DEPLOYMENT.
^
BEFORE INSTALLING THE SIDE AIR BAG MODULE, CHECK IT FOR DAMAGE AND FOREIGN OBJECTS. IF THE AIR BAG
MODULE IS DAMAGED, REPLACE IT. IF ANY FOREIGN OBJECTS ARE FOUND, REMOVE THEM. FAILURE TO DO SO MAY
RESULT IN PERSONAL INJURY, IN THE EVENT OF AN AIR BAG DEPLOYMENT.
^
IF THE AIR BAG COVER HAS SEPARATED OR THE AIR BAG MATERIAL HAS BEEN EXPOSED, INSTALL A NEW SIDE AIR
BAG MODULE. DO NOT ATTEMPT TO REPAIR THE AIR BAG MODULE. FAILURE TO DO SO MAY RESULT IN PERSONAL
INJURY IN THE EVENT OF AN AIR BAG DEPLOYMENT.
CAUTION: Make sure the side air bag module wiring harness is not pinched between the side air bag module and the mounting bracket.
2. Route the side air bag module wire harness. Install the pin-type retainers to the seat backrest frame.
3. Position the seat backrest pad onto the seat backrest frame.
WARNING: INSPECT THE SIDE AIR BAG CAVITY IN THE SEAT BACK PAD FOR ANY FOREIGN OBJECTS. IF ANY
FOREIGN OBJECTS ARE FOUND, REMOVE THEM. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY IN THE
EVENT OF AN AIR BAG DEPLOYMENT.
4. Install the seat backrest trim cover.
1
Position and roll the seat backrest trim cover down over the seat backrest frame and pad.
2
Attach the hook and loop strips.
