Escape 2WD L4-122 2.0L DOHC VIN B Zetec SFI (2003)
4. Remove the front safety belt retractor.
1
Disconnect the front safety belt retractor.
2
Remove the front safety belt retractor.
INSTALLATION
1. To install, reverse the removal procedure.
^
Make sure that after the front passenger safety belt retractor is installed, the retractor is not in the Automatic Locking Retractor (ALR) mode.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten bolts to specification.
2. Check the active restraint system for correct operation.
^
Carry out the Emergency Locking Retractor (ELR) Mode Functional Test to make sure that the new retractor operates correctly. See: Testing
and Inspection/Component Tests and General Diagnostics
