Escape 2WD L4-2.3L VIN Z (2005)
Trunk / Liftgate Latch: Service and Repair
Liftgate window Latch
LIFTGATE WINDOW LATCH
Removal and Installation
NOTE: Make sure the liftgate window glass is in the raised position.
1. Remove the liftgate trim panel.
2. Disconnect the liftgate window latch.
1
Disconnect the liftgate window latch ajar switch electrical connector.
2
Open the clip and disconnect the actuating rod.
3. NOTE: Mark the position of the liftgate window latch prior to removing the liftgate window latch bolts.
Remove the 2 liftgate window latch bolts and the liftgate window latch.
-
To install, tighten to 7 Nm (62 lb-in).
4. NOTE: The liftgate window latch must be checked to make sure the latch is installed and aligned correctly.
To install, reverse the removal procedure.