Escape 2WD L4-2.3L VIN Z (2005)
11. Check to make sure the index marks on the outboard track C-channel and plastic coated slide are still in alignment.
-
The index marks on the outboard track C-channel and plastic coated slide must align at this step. If the index marks do not match up, repeat
Steps 1 through 10.
12. Check to make sure the index marks on the inboard track C-channel and plastic coated slide are still in alignment.
13. NOTE: When assembled, a small gap between one of the gears and the drive tube may exist.
Assemble the seat track motor assembly, upper support assembly and inboard track together.
1
Align the drive tube to the motor stub shaft. Tap the nose of the inboard track gear toward the seat track motor stub shaft.
-
Positioning a block of metal or wood behind the motor gear can aid assembly.
2
While tapping the parts together, simultaneously engage the front and rear lift links to the inboard track.
-
When the lift links are up against the inboard track, with the bushings through the hole and seated, the drive tube is fully engaged.
