Escape 2WD L4-2.3L VIN Z (2005)
Refer to the appropriate Component or System to determine the location of the front air bag sensors.
The side impact sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped). Failure to follow these instructions may result in personal injury.
NOTE:
-
The driver seat and passenger seat are similar.
-
The power seat and manual seat are similar.
1. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes in the supplemental restraint
system (SRS) depower/repower procedure. Failure to follow these instructions may result in personal injury.
Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the 4 front seat track bolts.
-
To install, tighten to 23 Nm (17 lb-ft).
3. Disconnect the wiring harness from the front seat track and remove the front seat track.
4. To install, reverse the removal procedure.
-
Transfer components as necessary.
5. Install the front seat and repower the supplemental restraint system (SRS).
