Escape 2WD L4-2.3L VIN Z (2005)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Material
Removal and Installation
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
CAUTION: Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.
NOTE: When installing a new ABS module it must be configured using the vehicle as-built data and calibrated.
1. Remove the hydraulic control unit (HCU).
2. Remove the 3 ABS module screws.
^
To install, tighten to 2 Nm (18 inch lbs.).
3. Remove the ABS module.
4. To install, reverse the removal procedure.
