Escape 2WD L4-2.3L VIN Z (2005)
Vacuum Brake Booster: Service and Repair
Brake Booster
Removal and Installation
1. Disconnect the battery.
2. NOTE: Install new master cylinder nuts.
Remove and discard the 2 master cylinder nuts.
^
To install, tighten to 25 Nm (18 ft. lbs.).
3. NOTE: It is not necessary to disconnect the brake tube fittings.
Carefully position the brake master cylinder assembly forward.
4. Disconnect the vacuum hose/check valve assembly from the brake booster.
5. Remove the brake pedal position (BPP) switch.
6. If equipped, remove the speed control deactivator switch.
